Code 93; Enable/Disable Code 93; Set Lengths For Code 93 - Wasp Duraline WLS 8400 ER Series Product Reference Manual

8-32
WLS 8400 Product Reference Guide

Code 93

Enable/Disable Code 93

To enable or disable Code 93, scan the appropriate bar code below.
Enable Code 93
*
Disable Code 93

Set Lengths for Code 93

The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 93 may be set for any length,
one or two discrete lengths, or lengths within a specific range.
One Discrete Length - This option allows scanner to decode only those Code 93 symbols
containing a selected length. Lengths are selected from the numeric bar codes beginning on
page D-1 in Chapter D, Numeric Bar Codes. For example, to decode only Code 93 symbols
with 14 characters, scan Code 93 - One Discrete Length, then scan 1 followed by 4. In
case of an error, or to change the selection, scan Cancel on page D-7.
Code 93 - One Discrete Length