Stop Bit Select; Data Bits - Wasp Duraline WLS 8400 ER Series Product Reference Manual

6-14
WLS 8400 Product Reference Guide

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission of one
character and prepares the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving terminal
is programmed to accommodate. Set the number of stop bits to match host device
requirements.
*
1 Stop Bit
2 Stop Bits

Data Bits

This parameter allows the scanner to interface with devices requiring a 7-bit or 8-bit ASCII
protocol.
7-Bit
*
8-Bit