Table of Contents
Advertisement
Models:
CF550E
CF550ENH
CF550EV
CF750E
CF750ENH
CF750EV
Electric Fireplace
•
Important operating
a n d m a i n t e n a n c e
instructions included.
WARNING
If the information in these instruc-
tions is not followed exactly, a
fi re may result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• Comply with all minimum clearances to
combustibles as specifi ed. Failure to
comply may cause house fi re.
Heat & Glo • CRESTFIRE Series Electric Fireplace • 4030-239 Rev J • 04/05
CAUTION
DO NOT DISCARD THIS MANUAL
•
Read, understand
and follow these
instructions for safe
i n s t a l l a t i o n a n d
operation.
Owner's Manual
Installation and Operation
•
Leave this manual with
party responsible for
use and operation.
WARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
Glass and other surfaces are hot
during operation and cool down.
•
Keep children away.
•
CAREFULLY SUPERVISE children in same room
as heater.
•
Alert children and adults to hazards of high
temperatures.
•
Keep clothing, furniture, draperies and other
combustibles away.
1
Advertisement
Table of Contents
Related Manuals for Heat & Glo CF750ENH
Summary of Contents for Heat & Glo CF750ENH
- Page 1 Owner’s Manual Installation and Operation Models: CF550E CF550ENH CF550EV CF750E CF750ENH CF750EV Electric Fireplace CAUTION DO NOT DISCARD THIS MANUAL • Read, understand • Leave this manual with • Important operating and follow these party responsible for a n d m a i n t e n a n c e instructions for safe use and operation.
- Page 2 Read this manual before installing or operating this heater. Please retain this owner’s manual for future reference. Congratulations! Congratulations on selecting a Heat & Glo electric fi replace. The information contained in this owner’s manual unless noted otherwise, applies to all models. The insert you have selected is designed to provide the utmost in safety, reliability and effi...
-
Page 3: Table Of Contents
Table of Contents Listing and Code Approvals Operating Instructions A. Certifi cation ....... . . 4 A. -
Page 4: Listing And Code Approvals
Listing and Code Approvals A. Certifi cation This heater has been tested in accordance with the UL2021 Standards for fi xed and location-dedicated electric room heaters in the United States, the current CSA C22.2 No. 46 in Canada and has been listed by Underwriters Laboratories Inc. -
Page 5: Getting Started
Getting Started WARNING WARNING Improper installation, adjustment, alteration, service Fire Risk! or maintenance can cause injury or property damage. • Do not install or operate damaged Refer to the owner’s information manual provided with heater. this heater. For assistance or additional information •... -
Page 6: Design And Installation Considerations
B. Design and Installation Considerations D. Inspect Heater and Components CAUTION CAUTION Check building codes prior to installation. Sharp Edges • Installation MUST comply with local, regional, • Wear protective gloves state and national codes and regulations. and safety glasses during •... -
Page 7: Framing And Clearances
Framing and Clearances Note: Minimum and maximum clearances must be WARNING maintained at all times. Illustrations throughout these instructions refl ect typical installations and are for design Fire Risk purposes only. Actual installation may vary slightly due to Provide adequate clearances. individual design preferences. -
Page 8: Framing
C. Framing Figure 3.2 shows a typical framing (using 2 x 4 lumber) of the heater, assuming combustible materials are used. All re- quired clearances to combustibles around the heater must be adhered to. (CEILING) 30 in. min. (762 mm) 3/4 in. -
Page 9: Wiring
Wiring WARNING WARNING Shock Risk Shock Risk Fire Risk Improperly grounded outlets could cause electrical shock. Improperly protected power cords could • Always use properly grounded, fused and cause electrical shock or fi re. polarized outlets. • Do not pinch the cord or lay against a •... -
Page 10: 240Vac Hardwire Installation
C. 240VAC Hardwire Installation D. Wall Switch Wiring (12VDC) (Minimum 14 gauge three conductor wire, non-metallic *Do not connect wires to 120/240VAC* (hardwired heat- ers only) sheathing with ground.) • Turn off circuit breaker. • Turn off circuit breaker. • Remove access knockout located on the right side of •... -
Page 11: Heater Preparation
Heater Preparation A. Secure and Level the Heater Note: Follow all national and local electrical codes. WARNING Note: Select a suitable location that is not susceptible Fire Risk! • Prevent contact with sagging, loose to moisture and is away from drapes, furniture and high insulation. -
Page 12: Finishing
Finishing A. Finishing Material Note: Finishing materials are normally installed behind • Combustible Material the nailing fl anges or up to the sides of the nailing fl anges. Material which is made of or surfaced with wood, Allow room for the front to be added and the heater to be compressed paper, plant fi... -
Page 13: Mantel
C. Mantel (CEILING) 30 in. min. (762 mm) 3/4 in. - 12 in. (19 mm - 305 mm) Model CF550E Series 31-1/2 CF750E Series Mantel height listed is measured from the BASE of the heater. Figure 6.4 Mantel Specifi cations WARNING Fire Risk Do NOT obstruct air inlet or outlet grilles. -
Page 14: Heater Setup
Heater Setup A. Remove Shipping Materials Cut and discard ties securing the logs to the grate and bun- dling the fi rescreen. Remove screws holding ember bed shipping tabs in place (located in front of ember bed), re- move tabs and discard. Replace screws. B. -
Page 15: Operating Instructions
Operating Instructions It is recommended that during long periods of non- WARNING usage that the main power switch is turned to the “OFF” position. • Flame/Ember Bed Intensity Control Fire Risk Turn the control knob clockwise to increase the • Do not operate heater before reading and intensity. -
Page 16: Hand Held Remote Control Transmitter
CAUTION WARNING Odors and vapors released during initial HOT! DO NOT TOUCH. operation. SEVERE BURNS MAY RESULT. • Curing of high temperature paint. CLOTHING IGNITION MAY RESULT. • Open windows for air circulation. Glass and other surfaces are hot during Odors may be irritating to sensitive individuals. -
Page 17: Wall Switch Control
• Remote Transmitter Function D. FCC Requirements The hand held remote transmitter is only an ON/OFF If this equipment does cause harmful interference to radio control. When the transmitter is active, the remote or television reception, which can be determined by turn- LED light will be RED. -
Page 18: Troubleshooting
Troubleshooting A. Troubleshooting Guide Issues Possible Causes Solutions Heater doesn’t turn on with the main 1. Power switch is off. 1. Turn the power switch to the “ON” position. switch or remote transmitter. 2. Circuit breaker is tripped 2. May need to put the heater on a dedicated service or reduce the number of appliances on the circuit. -
Page 19: Maintenance And Service
Maintenance and Service A. Cleaning the Firebox and Control Compart- WARNING ment Keep the fi rebox, control compartment and heater system Shock Risk clean. Clean by brushing and vacuuming at least once a Burn Risk year. To access the control compartment, follow the instruc- Cleaning, performing maintenance or moving tions for replacing the light bulbs. -
Page 20: Heater/Blower Assembly Maintenance
D. Heater/Blower Assembly Maintenance • Turn off the circuit breaker/unplug the heater before servicing the heater/blower assembly. • Allow heater to cool before removing. • Open the lower grille panel to view the dashboard on the heater (the lower grille may need to be removed). •... -
Page 21: Reference Materials
14 in. (530 mm) 34-5/8 in. (356 mm) (879 mm) 41 in. (1041 mm) 6-1/2 in. 36-1/8 in. 3-1/8 in. (165 mm) (918 mm) (79 mm) CF750E/CF750EV/CF750ENH Heat & Glo • CRESTFIRE Series Electric Fireplace • 4030-239 Rev J • 04/05... -
Page 22: Optional Components
B. Optional Components SIGNAL LIGHT ON/OFF BUTTONS BATTERY COMPARTMENT FRONT BACK RCE-HNG-B DM1031 DM1036 WSK-21 WSK-21-W Remote Control DM1031B DM1036B Wall Switch Kit DM1031S DM1036S Bi-fold Glass Doors (left) (right) RF550E (CF550E Series) RF750E (CF750E Series) Side Refractory RF36EH Refractory (CF750E Series Only) RFH750E RFH550E... -
Page 23: Trim Kits
Fronts CF550E/CF550EV/CF550ENH CF750E/CF750EV/CF750ENH Item Description Item Description DF-550M Black Middle Door DF-750M Black Front PB-550 Polished Brass Strips (5) DF-6000 Black Front without Mesh BN-550 Brushed Nickel Strips (5) CDM-6-BK Cabinet Door Mesh - Black SRV550-175-PB Polished Brass Hood PB-750... - Page 24 Surrounds VTS-550 (CF550E Series) VTS-550-BK (CF550E Series) Flush Surrounds VTS-36 (CF750E Series) (chase installations only) VTS-36-BK (CF750E Series) CF550E Series CRF750E Series Quick Tile Black and Brass Surrounds ROF44SB_* ROF48DB_* MVF44SB_* MVF48DB_* no suffi x = Polished Brass Finish BK = Black Finish PLF44SB_* PLF48DB_* * O = Unstained Oak...
-
Page 25: Service Parts
D. Limited Warranty Hearth & Home Technologies Inc. 800 W. Jefferson Lake City, MN 55041 WARRANTY Hearth & Home Technologies Inc. (HHT) Electric Fireplaces are tested and inspected prior to shipment and are guaranteed from defect to the purchaser of each new product. Any part which proves to be defective in material or workmanship under normal use within one year will be repaired or replaced without charge.* The Company will not be responsible for any expense incurred for installation, removal from service, or transpor- tation costs. -
Page 26: Contact Information
E. Contact Information Hearth & Home Technologies Inc. 800 W. Jefferson Lake City, MN 55041 Please contact your Heat & Glo dealer with any questions or concerns. For the number of your nearest Heat & Glo dealer, please call 1-888-427-3973. –...