Heat & Glo COSMO Owner's Manual
Hide thumbs Also See for COSMO:

Advertisement

Quick Links

CAUTION! Risk of Fire! DO NOT store instruction manuals inside fireplace cavity. High temperatures
could cause a fire.
INSTALLER: Leave this manual with the appliance, not inside the appliance.
CONSUMER: Retain this manual for future reference. Do not store inside the appliance
NOTICE: DO NOT discard this manual!
Models:
COSMO-I30-IFT
COSMO-I35-IFT
This appliance may be installed as an OEM
installation in manufactured home (USA
only) or mobile home and must be installed
in accordance with the manufacturer's
instructions and the Manufactured Home
Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States, or the
Standard for Installation in Mobile Homes,
CAN/CSA Z240 MH Series, in Canada.
This appliance is only for use with the type(s)
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certified kit is used.
Owner's Manual
Care and Operation
Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner's Manual • 2535-981 Rev. K • 5/21
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
• DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
- If you cannot reach your gas supplier, call
the fire department.
• Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.
Pour demander un exemplaire en français de ce Manuel
du propriétaire, visitez www.heatnglo.com.
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
1

Advertisement

Table of Contents
loading

Summary of Contents for Heat & Glo COSMO

  • Page 1 Pour demander un exemplaire en français de ce Manuel  du propriétaire, visitez www.heatnglo.com. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 2: Welcome

    00,000 00,000 MIN. MIN. INPUT INPUT BTUH: BTUH: 00,000 00,000 00,000 00,000 Serial Serial XXXXXXXX XXXXXXXX ORIFICE ORIFICE SIZE: SIZE: #XXXXX #XXXXX #XXXXX #XXXXX (Serie): (Serie): Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 3: Table Of Contents

    C. Contact Information ......31   = Contains updated information. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 4: Limited Lifetime Warranty

    Firebox and heat exchanger, FlexBurn® System 3 years Lifetime (engine, inner cover, access cover and fireback) None 1 Year All purchased replacement parts Page 1 of 2 4021-645L 10/20 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 5 EXPRESSED WARRANTY SPECIFIED ABOVE FOR THE APPLICABLE PRODUCT. Some States do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Page 2 of 2 4021-645L 10/20 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 6: Product Specific Information

    HHT Factory Trained or NFI certified professionals. B. Glass Specifications This appliance is equipped with ceramic glass. Replace  glass only with ceramic glass. Please contact your dealer for replacement glass. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 7: Important Safety And Operating Information

    • Install a switch lock or a wall/remote control with child protection lockout feature. Figure 3.1 Clear Space Requirement - All Models Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 8: General Operating Parts

    For APPLIANCE SURROUND additional finishing guidelines, see Section 8 Installation Manual. Figure 3.3 Good Faith Wall Surface Temperatures Above Appliance Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 9 Sugges ons on how to further reduce TV temperatures: Increase “A” dimension. Increase “C” dimension, however, increasing “B” dimension beyond maximum recommended typically results in higher temperatures. Figure 3.4 Good Faith TV Guidelines  Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 10: Before Lighting Appliance

    • Verify collar slide plate screw is attached see Figure 3.5. BE SURE SLIDE PLATE SCREW IS FULLY TIGHTENED. Figure 3.5 Collar Slide Plate Screw Detail Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 11: Lighting Instructions (Ipi)

    For additional information on operating your Keep burner and control compartment clean. See installation and operating instructions Hearth & Home Technologies fireplace, please 593-913K accompanying appliance. refer to www.hearthnhome.com. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 12: Appliance Break-In

    See Section G. This break-in will ensure optimum speed control of the fan during subsequent use. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 13: Operation During A Power Outage - Intellifire Touch

    If not installed correctly, module functions that require the AC power. damage could occur. A complete wiring diagram is included in the Electrical section of the appliance installation manual. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 14 USB battery pack active USB CONNECTION to run the gas appliance. CONTROLS CAVITY Figure 3.3 HEARTH BATTERY BACKUP Figure 3.4 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 15: Detailed Component Operating Instructions - Intellifire  Touch

    2. If multiple control options are installed, the IFT-ECM ponents inside the appliance. will respond to the last command from the wired wall switch, IFT-RC400 or IFT-RC150. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 16 If the IFT-ECM re-enters the lock-out condition after these steps, call your dealer for service. SURROUND RESET SWITCH Figure 3.10 Surround Reset Switch Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 17: Maintenance And Service

    Note: Fixed glass assembly and gasketing may have residue that can stain carpeting or floor surfaces. • Remove door or decorative barrier front from fireplace and set aside on work surface. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 18 Verify top latches are fully engaged and then fasten the two bottom latches using the supplied multi-purpose tool. • Reinstall door or decorative barrier front. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 19 CAUTION: Be sure to reinstall the component heat shield  before firing the appliance. Components will overheat without the heatshield in place. CAUTION: Be sure to reinstall wires into the retaining clips.  Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 20: Maintenance Tasks - Qualified Service Technician

    • Verify that the collar slide plate screw is installed. See Figure 3.5. • Remove all foreign objects. • Verify unobstructed air circulation. • Ensure no wire connections become disengaged. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 21 Propane gas. Excess media on burner and base pan may cause sooting. One thin layer of media may require less media than indicated in the above media chart. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 22: Frequently Asked Questions And Troubleshooting

    (4 AA cell batteries required). Refer to Section 3.I for more details. Contact your dealer for additional information regarding operation and troubleshooting. Visit www.heatnglo.com to locate a dealer. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 23: Frequently Asked Questions - Intellifire Touch Controls (Ift-Rc400)

    90 seconds. If this failure appliance did not start. Try again period of appliance inactivity. persists, contact dealer for service. by pressing Flame On. Gas control system failure. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 24: Troubleshooting

    If open or shorted, replace valve. Check valve harness wire continuity, if open replace 6-pin harness. Pilot won’t light, there is no noise Spark coil failure. Replace ECM. or spark, 2 Red/2 Green Lockout. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 25 Damaged pilot assembly. tance between tip of sense rod and IFT-ECM connector, should be less than 1 ohm. Replace pilot assembly if damage is de- tected. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 26: Reference Materials

    For more information refer to the instructions supplied with your decorative barrier front. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 27: Service Parts

    Burner Assembly 2535-007 Base Pan 2535-130 Seal, Glass Frame 2532-122 GLA-2532 Glass Door Assembly 2201-024 Power Cord GFK-160A Additional service part numbers appear on following page. 5/21 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 28 Burner Assembly 2536-007 Base Pan 2536-130 Seal, Glass Frame 2533-122 GLA-2533 Glass Door Assembly 2201-024 Power Cord GFK-160A Additional service part numbers appear on following page. 5/21 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 29 Assembly, USB-C Bracket Post LC5673022 12.10 Wall Switch Jumper Wire SRV2179-300 12.11 SRV2326-152 Cable, B Type AC Module Additional service part numbers appear on following page. Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 30 593-526 Regulator NG NGK-DXV-50 Regulator Propane SRVLPK-DXV-50 **Fuse for battery pack can be sourced locally, not a warranty item. Specs are 250v, 3A fuse, 3/4” long Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...
  • Page 31: Contact Information

     7077122, 7074035, 7098269, 7234932, 7258116, 7322819, 7422011, 7470729, 7726300, 8147240, 9625149 or other U.S. and foreign patents pending. 2000-945E Printed in U.S.A. - Copyright 2021 Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner’s Manual • 2535-981 Rev. K • 5/21...

This manual is also suitable for:

Cosmo-i30-iftCosmo-i35-ift

Table of Contents