Install The Dc 5900 F - Shure DDS 5900 User Manual

5.9 Install the DC 5900 F Flushmount Discussion Unit
5.9.1 Installing the Base
The DC 5900 base installs directly onto a table or podium.
1. Determine the location of the microphone and cut a hole
with a diameter of 53 mm.
2. Use the base to mark the location for the screw and drill
the holes.
3. Secure the base to the table with the screws.
52 mm
42 mm
53 mm
46 mm
106 mm
5.9.2 Attaching the Front Plate
1. Align the front plate and place it onto the base.
2. Secure the plate to the base using the screws.
3. Snap the cover onto the front plate.
Figure 21. Attaching the Front Plate
5.9.3 Removal
To remove the front plate:
1. Locate the two holes on each side of the front plate.
2. Insert a paper clip in each hole to release the cover.
3. Pull up on the cover to separate the pieces.
4. Unscrew the front plate from base unit.
47 mm
cover
front plate
base
Figure 22. Use Paper Clips for Removal
5.9.4 Installing the Loudspeaker
1. Determine the location of the speaker (<1m from the
base to accommodate the cable) and cut a hole with a
52 mm diameter.
2. Insert the loudspeaker into the hole and connect the
loudspeaker cable to the base unit. Make sure the cable
is not pinched.
3. Align the loudspeaker with the base unit. Mark the
location for the screws, spaced exactly 78 mm apart.
4. Drill the holes and secure the speaker to the table with
the screws.
5. Snap the grill onto the loudspeaker cabinet.
6. Connect the cable from the loudspeaker to the DC 5900
F base
29 mm
30.5 mm
Figure 23. Bottom of LS 5900 F
78 mm
91 mm