Shure DDS 5900 User Manual page 22

5.3.5 Audio Recorder
Connect an audio recorder to the analog outputs of the CU to record floor audio, translations, or a specific set of
microphones. Use the browser interface to select groups and assign outputs. Connect the XLR outputs of the CU to the
inputs of an audio recorder.
Analog outputs to recorder
Figure 15. Recording Audio
5.3.6 Mixer or DSP
Connect a mixer to control individual microphone volume or equalization. One or more outputs are connected to the
external mixer, where the control or equalization is done. Use the browser interface to select groups and assign outputs.
Connect the XLR outputs of the CU to the inputs of the mixer or DSP. Connect the output of the unit to the CU Audio
Input 1.
Important: If 'Out A' is also send to the mixer, configure the following settings:
• 'CU 5905 Setup > Audio > Loudspeaker Control > Microphone -> Loudspeaker' set to 'Off'.
• 'In 1 -> Out. A' is set to un-selected in the selection 'CU 5905 Setup Audio > Input/Output Control > Audio In 1'.
Figure 16. Inserting a Mixer or DSP