Shure DDS 5900 User Manual page 13

Digital discussion system
Hide thumbs Also See for DDS 5900:
Table of Contents

Advertisement

4.1.1 CU Interface Description
① Menu display
A 2x20 character OLED-display enables system
configuration without a computer.
② Navigation Buttons
5-button keypad for configuring the system without a
computer.
③ Power Button
The power button turns on or off the central unit. All
connected discussion units and power supplies will
automatically power on.
• Green = powered on
• Red = powered off but connected to power supply
• Off = no power supply is connected to the unit
④ Power Supply Connector
Threaded connector secures to the PS CU power supply.
⑤ Chain outputs
Two RJ45 jacks are available for connecting the discussion
units, forming the DCS-LAN. The DCS-LAN chain safely
carries digital audio, control data, and power over the
same cable. The CU operates a single mix from the two
separate discussion unit chains, enabling more flexible
installations and system connections.
Important: Only connect DDS 5900 discussion units to this output.
Figure 3. CU 5905 Central Unit
⑥ Control Connector (TCP/IP)
The RJ45 connector allows access the built-in web
application from a computer, or for connection to a control
system like AMX
⑦ Audio Outputs
Four balanced, male XLR connectors for connection to
PA systems, audio mixers, audio recorders, or a language
distribution system.
⑧ Audio Inputs
Two balanced, female XLR connectors for connecting
wireless microphones, processed audio signals, an
emergency broadcast message (EEM), or music during
meeting breaks.
• Input 1: Connect an additional audio source; gain is adjustable.
• Input 2: Connect an Emergency Evacuation Message (EEM)
audio signal.
⑨ Emergency switch connector
A terminal block connector for a 'normally open' switch.
When the switch is closed, the audio signal on the 'In 2'
connector is distributed to all output channels, overriding
all other audio inputs.
Note: There is no volume control available for setting the volume on 'In 2'. The
volume has to be set at the equipment generating the "Emergency Evacuation
Message (EEM)" audio signal.
Front
Back
or Crestron
.
®
®

Advertisement

Table of Contents
loading

Table of Contents