Shure DDS 5900 User Manual page 50

<path> Indicates which connection is being controlled.
Possible values are: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A' or
'linein_1_to_floor'.
11.3.6 Request Audio Status
audio_status<CR>
Provides system audio status.
The CU responds to this command by issuing a list of
commands for the Audio settings:
11.3.7 Commands from CU 5905 to External Control
11.3.8 Loudspeaker Volume
loudspeaker_volume <volume><CR>
Indicates the volume of loudspeakers for all Discussion
Units.
11.3.9 Line Input 1 Level
line_input_level_1 <level><CR>
Indicates the level of the line input 1 signal.
11.3.10 Line Output Level (A-D)
line_output_level <output> <level><CR>
Adjusts the level of the line output signal.
<output> Indicates which output is being controlled.
Possible values are: 'A', 'B', 'C' or 'D'.
11.3.11 Define Audio Path
audio_path <path> <on/off><CR>
This command defines audio connections in the system.
11.3.12 Audio Status Complete
audio_status_done<CR>
This command terminates audio status streaming.
<on/off> Indicates whether the audio is being routed from
microphones/lineinput_1 to speakers/lineoutput/floor.
The CU responds to this command by issuing the audio_
path command.
loudspeaker_volume
line_output_volume (for all outputs A-D)
audio_path (for all paths)
line_input_level
audio_status_done
<volume> The volume of the loudspeakers ranges from
-41 to 0. The value -41 indicates the volume is Off. Values
from -40 to 0 indicate attenuation in dB.
<level> The level of line input 1 ranges from -41 to 0. The
value -41 indicates the level is zero. Values from -40 to 0
indicate attenuation in dB.
<level> The level of the line output ranges from -41 to 0.
The value -41 indicates the output is zero. Values from -40
to 0 indicate attenuation in dB.
<path> Indicates which connection is being controlled.
Possible values are: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A' or
'linein_1_to_floor'.
<on/off> Indicates whether the audio is being routed from
microphones/lineinput_1 to speakers/lineoutput_A/floor.