Yamaha F225F Service Manual page 506

BRKT
Removing the clamp bracket
1. Remove the PTT unit. See "Removing
the PTT unit" (9-32).
2. Remove the anode a.
3. Remove the ground leads b and c.
4. Remove the self-locking nut d and
through tube e, and then disassemble
the clamp brackets f and g.
b
d
g
a
5. Remove the trim sensor h.
6. Remove the spring i, hook j, and pins
k.
9-27
Bracket unit
c
e
f
h
i
j
7. Remove the tilt stop levers l and m,
distance collar assembly n, collar o,
and bushings p.
p
m
n
p
o
Checking the clamp bracket anode
1. Check the anode. Replace if eroded.
Clean if there is grease, oil, or scales.
NOTICE: Do not apply grease, oil, or
paint to the anodes.
Installing the clamp bracket
1. Assemble the distance collar assembly.
Distance a:
30.3–30.4 mm (1.19–1.20 in)
k k
p
l
a