Yamaha F225F Service Manual page 304

POWR
3. Install the starter motor lead b, and then
tighten the starter motor lead screw b to
the specified torque.
Starter motor lead screw b:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
4. Install the ground leads c, d, and e.
5. Connect the shift actuator coupler f.
c
d
6. Connect the Rectifier Regulator coupler
g.
7. Connect the PTT relay coupler h.
7-21
Power unit
b
b
f
e
g
8. Connect the fuse holder couplers k and
m, Rectifier Regulator couplers n, p,
and r, power source coupler s, and
isolator coupler t.
9. Remove the fuse box c, and then tighten
the fuse box screw d to the specified
torque.
c
d
d
d
d
Fuse box screw d:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
10. Install the ground leads u.
11. Connect the oil pressure sensor coupler
v.
h
r
p
s
t
n
k
m