Paging - Comdial CONVERSip EP100 User Manual

To maintain the extension number and programming features from
the old location,
1. Connect the telephone line cord to the new jack.
2. Observe the flashing HOLD light and press HOLD while the
light is still flashing (your telephone immediately assumed the
features from the previous location).
Note: If you do not select a button after installing the telephone, the
system automatically defaults to the programming from the previous
location.
To assume the extension number and programming features from the
new location,
1. Connect the telephone line cord to the new jack.
2. Observe the flashing HOLD light and dial # while the light is
still flashing (your telephone immediately assumes the features
from the new location).

7.13 Paging

Your system provides an all-call or a zone page feature that you
access by dialing special codes. This arrangement sounds your voice
announcement through the telephone speakers or through an external
paging unit.
To send a paging announcement,
1. Lift handset.
2. Press INTERCOM.
3. Dial 70 through 77 for zones 1–8. Note: Zone 1 (code 70)
provides an all-call function in the default mode.
4. Make announcement.
5. Remain on line if awaiting a reply (known as a Meet-Me page),
or hang up handset.
Sept '04
Comdial
CONVERSip EP100 User
95