Install The Front Plate; Thermostat Connection - Vermont Castings SDDVRBD, SDDVRC, SDDVRCCB Installation And Operating Manual

Stardance Direct Vent - Rear Vent Gas Heaters
Fig. 49 Attach switch wires to valve.

Install the Front Plate

ST228
Grasp the Front Plate and lift it into position, engaging
attach switch
the two steel tabs at the upper corners behind the adja-
wires to valve
cent bosses in the Side Plates. (Fig. 50) Seat the Front
12/99
against the Sides so that the tabs at the bottom lip
engage with the notches in the edge of the stove base.
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without also lifting
it up.
If you are installing optional Warming Shelves, do so
now, according to the instructions supplied with that kit.
Bottom Tabs
Engage Notch in
Base
Fig. 50 Install Stove Front.
28
ST228
ST940
ST940
Stardance
Remove Front
6/07

Thermostat Connection

(Optional) R Models Only
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge
thermostat wire to use for the length of lead required in
your installation.
Thermostat
Wire / Gauge
18
20
22
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4" female connectors.
2. Connect the thermostat wires to the valve. (Fig. 49)
This completes assembly of the Stardance Rear
Vent stove.
Maximum Run
40 feet
25 feet
16 feet
20012950