Install The Front Plate; Thermostat Connection - Vermont Castings SDVR Series Homeowner's Installation & Operating Manual

Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
Switch As-
sembly
Screws
Fig. 40 Attach switch assembly to rear shroud.
Fig. 41 Attach switch wires to valve.

Install the Front Plate

ST228
Grasp the Front Plate and lift it into position, engaging
attach switch
the two steel tabs at the upper corners behind the adja-
wires to valve
cent bosses in the Side Plates. (Fig. 42) Seat the Front
12/99
against the Sides so that the tabs at the bottom lip
engage with the notches in the edge of the stove base.
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without also lifting
it up.
If you are installing optional Warming Shelves, do so
now, according to the instructions supplied with that kit.
Bottom Tabs
Engage Notch in Base
Fig. 42 Install Stove Front.
24
Existing
Holes
ST228
ST315
attach switch assy
1/31/00 djt
ST407a
install front
12/19/03
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge
thermostat wire to use for the length of lead required in
your installation.
Thermostat
Wire / Gauge
ST315
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4" female connectors.
2. Connect the thermostat wires to the valve. (Fig. 41)
This completes assembly of the PDV20 and SDVR
stove.
ST407

Thermostat Connection

(Optional) R Models Only
Maximum Run
18 40 feet
20 25 feet
22 16 feet
20007066