Operation; Your First Fire; Pilot And Burner Inspection; Flame & Temperature Adjustment - Vermont Castings SDDVRBD, SDDVRC, SDDVRCCB Installation And Operating Manual

�������
�
The Stardance is operated with the front plate in place
with the doors open or closed. To open the front doors,
pull forward to separate the magnetic catch.
CAUTION: DO NOT TOUCH DOORS WHEN
HOT!

Your First Fire

Read these instructions carefully and familiarize
yourself with the burner controls shown in Figure 55.
Locate the pilot assembly, Figure 68. Follow the lighting
instructions on Page 33 exactly.
During the first fire, it is not unusual to smell some
odor associated with new logs, paint and metal being
heated. Odors should dissipate within a few hours. You
can open a window to provide fresh air to alleviate the
condition.
Manifold Pressure Tap
Pilot Adjustment
Screw
Fig. 55 RADVT valve control.
�����
��� �����
����
20012950

Operation

��� ����� ����
����� ������
�� ��� ����� �����
����� �������
����� ����� ��������
�� ����� ������
Inlet Pressure Tap
� �
Gas Control
Regulator
Knob
Control Knob
ST941
Stardance Direct Vent - Rear Vent Gas Heaters

Pilot and Burner Inspection

Each time you light your heater check that the pilot
flame and burner flame pattern are as shown in Figure
58. If flame patterns are incorrect, turn the heater off.
Contact your dealer or a qualified gas technician for as-
sistance. Do not operate the heater until the pilot flame
is correct.
Follow regular maintenance procedures as described
on Page 42.
Fig. 56 Pilot assembly location.
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjust-
ment is accomplished by rotating the HI/LO adjustment
knob located near the center of the gas control valve.
(Fig. 57)
Turn
counterclockwise
to increase
flame height
Fig. 57 Flame adjustment knob for SIT valve.
FP390
FLAME ADJUSTMENT KNOB
11/21/96
ST935
SDDVT
pilot location
6/07
Turn clockwise
to decrease
flame height
ST935
31