Checking Customer Options; Enabling Announcements - Avaya IG550 Installing And Configuring

Administering Communication Manager on the media server to support the IG550 Integrated Gateway
Note:
The slot display in the Media Gateway screen does not match the display when
Note:
using the TGM550 CLI command show mg list. In the show mg list
display, the TGM550 is always in virtual slot 0 and the analog motherboard for
analog connections displays in the physical slot of the TGM550.
c
SLOT
----
V0
V1
V2
V3
V4

Checking Customer Options

If announcements are planned for the TGM550:
1. At the SAT command line, type display system-parameters customer-options,
and press Enter.
The Optional Features screen appears.
2. Press NEXTPAGE to display page 2.
Page 2 of the Optional Features screen appears.
3. Check the Maximum Media Gateway VAL Sources field to verify that VAL sources are
available.

Enabling announcements

1. Only if specifically requested by the customer or your planning documents, at the SAT
prompt, type enable announcement-board <gateway_number> V9
where <gateway_number> is the number of the Juniper Service Router you added.
V9 is the virtual slot (for example, 2V9 means media gateway number 2, slot V9.
Note:
The enable announcement-board command fails if you did not complete the
Note:
V9 field on the Media Gateway screen.
130 Installing and Configuring the IG550 Integrated Gateway
TYPE CODE SUFFIX
------ --------- ------
TGM550 A
Analog <onboard> A
Analog TIM514 A
E1T1 TIM510 A
BRI TIM521 A
HW VINTAGE FW VINTAGE
---------- ----------
0 26.17.0(A)
0 N/A
0 0
1 0
1 0