Chapter 5: Installing An Ig550 Integrated Gateway With An Existing Juniper J4350/J6350 Services Router; Checking Juniper Firmware Compatibility - Avaya IG550 Installing And Configuring

Chapter 5: Installing an IG550 Integrated Gateway
Note:
If you are installing both the TGM550 and the J-series router to a new site to
Note:
provide both LAN/WAN and communications system service, see
2: Installing an IG550 Integrated Gateway using the Disk on Key
In this scenario, the customer adds a TGM550 when a router already connects a site to the
customer's LAN or WAN and the customer adds either a communications system or a new
location to an existing communications system.

Checking Juniper firmware compatibility

The software for the J-series router must be release 8.2 or higher. If it is not, upgrade the router
software to release 8.2 before continuing with the installation. See the Juniper J4350 and J6350
Services Router Getting Started Guide, Release 8.2.
!
CAUTION:
Neither the TIMs nor the TGM550 should be inserted into the J-series router
CAUTION:
before you are sure the router is running release 8.2 or higher. Failure to comply
with this caution may cause your system to become inoperable.
Also, check what Juniper software is compatible with the specific TGM550 firmware load you
are downloading. You might need to install newer router firmware before you install new
TGM550 firmware.
1. Go to http://support.avaya.com, and select Communication Manager from the most
popular documents list or by searching by product name.
2. Search All Documents for Communication Manager Software & Firmware Compatibility
Matrix.
with an existing
Juniper J4350/J6350 Services Router
Chapter
on page 11.
Issue 1.1 May 2007 97