Table of Contents
Advertisement
Figure 110. Removing a processor retainer
Note: When the processor is out of its retainer, hold the processor by the long edges to prevent
touching the contacts or the thermal grease, if it is applied.
With the processor-contact side up, flex the ends of the retainer down and away from the processor
to release the retaining clips; then, remove the processor from the retainer. Discard the old retainer.
b. Install a new processor retainer.
Figure 111. Installing a processor retainer
1) Position the processor on the new retainer so that the triangular marks align; then, insert the
unmarked end of the processor into the retainer.
2) Holding the inserted end of the processor in place, flex the opposite end of the retainer down
and away from the processor until you can press the processor under the clip on the retainer.
To prevent the processor from falling out of the retainer after it is inserted, keep the processor-
contact side up and hold the processor-retainer assembly by the sides of the retainer.
.
Chapter 9
Hardware replacement procedures
195
Advertisement
Table of Contents
