Lenovo ThinkAgile VX7820 User Manual page 90

discovered after the web interface times out, refreshing the page displays the newly discovered
servers.
• If ThinkAgile VX servers are not discovered, ensure that the ThinkAgile Installer has access to all
networks to which the servers are connected.
• Nodes must be added to the DNS.
Hosts tab
On this page, specify the vSAN host settings, such as the vSAN IPv4 address and the subnet mask in
CIDR format.
Note: For more information about Classless Inter-Domain Routing (CIDR), see the
Domain Routing webpage
If the IP addresses for the hosts in the vSAN cluster are sequentially numbered, click Populate Network
Infos to enter a starting IP address (rather than having to repeatedly type in the IP address.
vCenter tab
On this page, specify the details of the vCenter instance on which the vSAN cluster will be deployed.
You can choose to connect to an existing vCenter instance, or the ThinkAgile Installer can create a new
vCenter instance based on the configuration information that you provide.
• Deploy vSAN on Existing vCenter. If you choose to connect to an existing vCenter instance, specify
the information about the vCenter instance, such as vCenter name, IP address or hostname,
credentials, datacenter name, and cluster name.
• Deploy vCenter on Existing Datastore
• Deploy vCenter on New vSAN Datastore. If you choose to deploy a new vCenter appliance, specify
the following information:
– Host network settings. Specify the network settings for the host on which the vCenter appliance
will be deployed, such as IPv4 address or hostname, access credentials, port group, and datastore
name.
– vCenter appliance network settings. Specify the network settings to be applied to the vCenter
appliance, such as the IPv4 address or hostname , IP settings, gateway and subnet mask.
– Single sign-on credentials. For more information about vCenter Single Sign On, see the
Configuring vCenter Single Sign On webpage
– Login credentials. Specify the password for the vCenter appliance and whether or not SSH is
enabled.
Review tab
On this page, all of the settings that you specified are listed for your review. Make sure that the settings
are correct.
When you click Next, the settings are validated and any issues are displayed for your resolution. Click
the Back button to make any corrections that might be needed. After the settings have been validated,
the vSAN cluster creation process begins. If you chose to create a vCenter appliance, it is created as
well.
Status tab
On this page, the status of the vSAN creation process is displayed. If there are issues, see ThinkAgile
Installer Event Codes for information about resolving issues.
Note: The vSAN creation process can take up to an hour to complete.
Troubleshooting the ThinkAgile Installer
If the vCenter deployment fails:
User Guide for ThinkAgile VX7820 Appliance, ThinkAgile VX 4-Socket 4U Certified Node
80
.
.
Classless Inter-