components, such as electrical connectors in the processor socket. Do not remove the grease cover from
a heat sink until you are instructed to do so.
Before you remove a PHM:
Note: The heat sink, processor, and processor retainer for your system might be different than those shown
in the illustrations.
1. Remove the front cover. See "Remove the front cover" on page 131.
2. Remove the compute tray where the system board is installed. See "Remove a compute tray" on page
115.
3. If you are removing a PHM from the lower system board, remove the upper system board or system
board filler. See "Remove a system board" on page 109.
Figure 106. Processor locations on system board
Figure 107. Processor layout for multi-processor systems (viewed from front of server)
Complete the following steps to remove a PHM.
Watch the procedure. A video of the replacement process is available:
•
YouTube
.
Chapter 9
Hardware replacement procedures
191