Lenovo ThinkAgile VX7820 User Manual page 172

2. Run the following command to set the TPM version:
Note: You can change the TPM version from 1.2 to 2.0 and back again. However, you can toggle
between versions a maximum of 128 times.
To set the TPM version to version 2.0:
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update to TPM2.0 compliant"
--bmc userid:password@ip_address
To set the TPM version to version 1.2:
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update to TPM1.2 compliant"
--bmc userid:password@ip_address
where:
• <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o)
• <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI s s e e t t command, see:
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
3. Alternatively, you can use the following Advanced Settings Utility (ASU) commands:
To set the TPM version to version 2.0:
asu64 set TPMVersion.TPMVersion "Update to TPM2.0 compliant" --host <ip_address>
--user <userid> --password <password> --override
To set the TPM version to version 1.2:
asu64 set TPMVersion.TPMVersion "Update to TPM1.2 compliant" --host <ip_address>
--user <userid> --password <password> --override
where:
• <userid> and <password> are the credentials used to the BMC (Lenovo XClarity Controller interface)
of your server. The default user ID is USERID, and the default password is PASSW0RD (zero, not an
uppercase o)
• <ip_address> is the IP address of the BMC.
Enable UEFI Secure Boot
Optionally, you can enable UEFI Secure Boot.
Physical Presence must be asserted if you are going to enable UEFI Secure Boot. See "Assert Physical
Presence" on page 161.
For information about accessing the Lenovo XClarity Controller interface, see:
http://sysmgt.lenovofiles.com/help/topic/com.lenovo.systems.management.xcc.doc/dw1lm_c_chapter2_
openingandusing.html
There are two methods available to enable UEFI Secure Boot:
• From Lenovo XClarity Provisioning Manager Lite
To enable UEFI Secure Boot from Lenovo XClarity Provisioning Manager Lite:
1. Start the server and when prompted, press F1 to display Lenovo XClarity Provisioning Manager Lite.
2. If the power-on Administrator password is required, enter the password.
3. From the UEFI Setup page, click System Settings ➙ Security ➙ Secure Boot.
User Guide for ThinkAgile VX7820 Appliance, ThinkAgile VX 4-Socket 4U Certified Node
162