Avaya S8500 Upgrading Software And Firmware page 54

Upgrading firmware on programmable circuit packs
3
Press Enter to submit the schedule.
If you set the Schedule Download field to n, the download starts as soon as you submit the
schedule.
4
If the download is scheduled for later, ensure that the download will run as you intend by testing
the firmware download. Go to
54
NOTE:
If you are scheduling firmware downloads for a circuit pack that is designated as
primary/secondary sync (timing) source (for example, TN464GP), this procedure
automatically redesignates a local timing source during the download. After the download
is complete and the circuit pack is returned to service, the procedure designates the
original circuit pack as the timing source.
NOTE:
The target circuit packs are automatically removed from service while the firmware is
downloaded to them and automatically returned to service after the download is
completed. While a circuit pack is removed from service, any active calls through that
circuit pack are dropped.
NOTE:
An error message asking you to use the command,
there was a problem with a previous firmware download. Run the test before proceeding.
Go to Testing firmware download
CAUTION:
Unless the Remove Image File After Successful Download
and remain on the TN799DP or TN799C (C-LAN) and TN2501AP (VAL)
ftppassword
circuit packs either until they are reset or until you type
UUCSS .
Testing firmware download
Upgrading Software and Firmware—S8500 Configuration
test firmware download
on page 56.
disable filesystem board
on page 56.
, means that
field is set to y, the ftplogin
December 2003