Reverting To An Older Tn799Dp Or Tn2501Ap Vintage - Avaya S8500 Upgrading Software And Firmware

Upgrading firmware on programmable circuit packs
Reverting to an older TN799DP or TN2501AP
vintage
To revert back to the old firmware image file on a TN799DP (C-LAN) or TN2501AP (VAL) only:
1
Type get boot-image UUCSS
target circuit pack.
get boot-image 1C07
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 09/13/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: Yes
2
Check the
image resides.
3
Check the
In the following example, we are reverting back to Image 2, because it has the older date and time
stamp.
4
Type set boot-image board UUCSS image 1 | 2
Example:
The system responds with
5
Type get boot-image UUCSS
target circuit pack.
get boot-image 1C07
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 09/13/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: No
58
and press Enter to check the status of the firmware images on the
DISPLAY FIRMWARE IMAGE(S)
Image 1 Image 2
TN2501
01
02
A
05/06/02
12:42:18
Good
No
No
Active Image: field in the
Date and Timestamp fields to determine whether to revert back to a previous image.
NOTE:
In most cases, the image with the more recent date and time stamp is the new firmware
image file.
set boot-image board 1C07 image 2
Command Successfully Completed
and press Enter to check the status of the firmware images on the
Image 1 Image 2
TN2501
01
02
A
05/06/02
12:42:18
Good
No
Yes
Upgrading Software and Firmware—S8500 Configuration
Image 1 and Image 2 columns to see where the active
and press Enter.
DISPLAY FIRMWARE IMAGE(S)
.
December 2003