Reconfigure The Media Server; Enable Scheduled Maintenance; Verify Survivable Remote Pns - Avaya S8500 Upgrading Software And Firmware

Reconfigure the media server

After a software upgrade, you must reconfigure the media server to ensure inclusion of the software
changes to the Configure Server functionality. Also, it is possible that the new software added or changed
some of the configuration fields or screens.
1
Under Server Configuration click Configure Server to start the configure server process.
2
Click Continue through the Review Notices to get to the Select Method for Configuring Server
page.
3
Select "Configure all services using the wizard" and click Continue.
4
Click Continue through all the screens, checking for new screens and new fields on existing
screens as mentioned in the Software Release Letter.
5
When you complete all the new fields, if necessary, click Continue on the Update System screen.
The Update System screen displays each configuration task as it completes. When done, the
screen displays the line "All configuration information was entered."
6
Click Close Window to close the Configure Server wizard.

Enable scheduled maintenance

1
Type change system-parameters maintenance and press
2
Ensure that the
upgrade.

Verify Survivable Remote PNs

If the system is equipped with an SRP, you need to return it to its standby status from the SRP itself.
1
Type
restore survivable
Upgrading Software and Firmware—S8500 Configuration
December 2003
NOTE:
You must click through all the screens whether there are changes or not.
NOTE:
Tasks Enable scheduled maintenance
Start Time and Stop Time
and press Enter to put the SRP back to standby mode.
Upgrading Communication Manager—R2.0 to R2.X
on page 35 through use SAT commands.
.
Enter
fields' administration is the same as before the
35