Avaya S8500 Upgrading Software And Firmware page 52

Upgrading firmware on programmable circuit packs
Table 3: Firmware Download fields and descriptions 2 of 2
Field
Remove Image File
After Successful
Download
Start Date/Time
Stop Date/Time
Target Location
52
Description
Type y if you want the
procedure to automatically
remove the new firmware
image file [default].
Type n if you do not want the
new firmware image file
removed.
Type the date and time that you
want the firmware download to
begin.
Type the date and time that you
want the firmware download to
end.
Type the UUCSS address of the
circuit pack that you are
updating.
Upgrading Software and Firmware—S8500 Configuration
Notes
At the completion of a successful
download, the procedure
automatically removes the new
firmware image file from the source
file system, freeing up the memory
on the source circuit pack. We
recommend using the default setting.
If field is set to n, you must
manually remove the new firmware
image file from the source file
system after the download has
completed. (See Disable file system
on page 55 for instructions.)
If the scheduled stop time is reached
before the new firmware image file
has been downloaded to every circuit
pack, the system finishes
downloading to the circuit pack in
progress before aborting the
remainder of the download schedule.
For a self download, this circuit pack
must reside in the same location as
the source pack.
For a C-LAN-distributed download,
enter up to 50 locations — these
must all be the same type of circuit
pack.
December 2003