Set Alert - Uniden UBCD996T Owner's Manual

!
Edit Frequency
monitor for the tone-out.
!
Set Modulation
choose the modulation setting:
— The scanner uses the default modulation for the frequency band. If
Auto
the default modulation is AM, WFM, or FMB, the modulation operates as
FM.
— The scanner uses FM for the frequency band. This is the default
FM
setting.
— The scanner uses NFM modulation.
NFM
— Turn the Scroll Control to select
Set Attenuation
— Sets the audio tone frequency for the page. Then choose the Tone
Set Tone
setting.
!
Edit Tone A
!
Edit Tone B
Notes:
! For two-tone pages, enter a value for A and B.
For one-tone pages using short tones of less than 3.75 seconds, enter the
!
tone value for A, and 0 (zero) for B.
! For long-tone pages, such as group pages of more than 3.75 seconds, enter
0 (zero) for A and the tone value for B.
— Sets the time the scanner remains in monitor mode after the
Set Delay Time
scanner receives a page and the carrier drops.
— the scanner resumes standby mode after the carrier drops and
1-5 sec
the selected time expires.
— you must press
Infinite
standby mode.
— the scanner resumes standby as soon as the carrier drops after a
Off
page.
— Sets the alert the scanner uses when it receives an alert.

Set Alert

- — scroll to select the alert tone pattern, The scanner sounds
Alert 1 9
each alert as you scroll to its numbered value.
— the scanner does not sound an alert.
Off
— Enter the desired frequency that the scanner should
— Set the modulation type for the paging signal. Next
— Set the audio frequency for Tone A
— Set the audio frequency for Tone B\
[HOLD/RESUME]
115
or .
On Off
after a page to resume