Uniden UBCD996T Owner's Manual page 32

UBCD996T
To secure the radio, by means of the mounting bracket, to a surface, follow the steps
below:
1. Attach the four protective rubber feet to the mounting bracket when you casually
use the scanner on a flat surface. Should you desire to permanently mount the
scanner, remove the feet and use wood screws through the bracket as described
in Steps 2 and 3.
2. Use the bracket as a template to mark positions for the two mounting screws.
3. At the marked positions, drill holes slightly smaller than the screws.
4. Align the bracket with the threaded holes on the sides of the radio case so the
bracket is beneath the radio. Secure the bracket using the two threaded knobs.
Never overtighten the knobs.
Once the radio is positioned, connect it to a source of AC power using the supplied
13.8V, 700 mA AC adapter. Insert the barrel of the AC adapter to the jack on the
rear, upper right side of the radio marked
MOUNTING WOOD SCREWS
.
32