Set Modulation - Uniden UBCD996T Owner's Manual

Note: If you select Control Channel Only mode (see "Setting Control-Channel Only
(Motorola Systems Only)" on Page 81), you only need to enter the frequency(s) that
can be assigned as the control channel. Most frequency lists usually indicate which
of the frequencies are the control channel frequencies. Otherwise, you must enter all
of the frequencies.
Setting Site Modulation
[MENU]
Program System
Select a trunked system
Edit Site
Select a Site

Set Modulation

— the scanner uses the default modulation for the frequency band.
Auto
— the scanner uses FM (frequency modulation) for the frequency band.
FM
— the scanner uses narrowband FM for the frequency band.
NFM
Note: The default setting is
This setting controls the modulation method used for the frequency band. In most
cases, if you leave this set to
modulation type for the system you are programming.
Setting Site Attenuation
Enable Attenuation if you are near strong signal sources. Attenuation can help
reduce interference and desensitization that strong signals create. You can also turn
this setting on or off by holding on a trunked system, then pressing
[MENU]
Program System
Select a trunked system
Edit Site
Select a Site
Set Attenuator
— the attenuator is off.
Off
— site frequencies are attenuated by about 20 dB.
On
Setting Site Lockout
[MENU]
Program System
Select a trunked system
.
Auto
, the scanner automatically selects the correct
Auto
79
ML
MESL
+ [7] .
MESL