Set Close Call Alert; Setting Of Pager Screen; Alert Tone Volume; Alert Light Adjustment - Uniden UBCT9 Owner's Manual

Set Close Call Alert

This option controls whether the scanner sounds an
additional alert tone when a Close Call signal is detected.
Press or to select the option, and then press E.

Setting of pager screen

This option sets whether the scanner screens common
pager frequencies from hits during Close Call searching.
1. Press or
Pager Screen On : The scanner ignores hits on common pager frequencies.
Pager Screen OFF : The scanner does not screen for common pager frequencies.
Note: Pager screen affects the following frequency range.
148.0000 - 149.2500 MHz
2. To return to previous mode, press

Alert Tone Volume

Push VOL to select Loud, Medium, or Soft.
The Alert Tone beeps and the alert light flashes to
confirm your choice.

Alert Light Adjustment

The Alert Light has three settings (Bright, Dimmer, Off).
• Push SQL to select Bright, Dimmer or Off.
The Alert Light flashes and the alert tone beeps.
If you select Off, "FLASH" will be displayed to
remind you the Alert Light is Off.
UBCT9 OM 20
to select the option, and then press E.
(decimal key).
0
12/11/07 3:53:38 PM