Setting The Backlight Color; Adjusting The Key Beep; Setting The Audio Agc - Uniden UBCD996T Owner's Manual

— If the headlight wire is connected to vehicle ground when the
- Polarity
headlights are on, pick this setting.
— Use this setting to manually set the dimmer level to
Manual
or . To guide you in your selection, at each setting the display shows what you
Off
can expect to see.

Setting the Backlight Color

[MENU]
Settings
Set Backlight
Set Color
Set this option to either Red or Green.

Adjusting the Key Beep

[MENU]
Settings
Adjust Key Beep
— the scanner automatically sets the key beep to match the master volume
Auto
setting level you select.
- — the scanner lets you manually select one of fifteen key beep
Level 1 15
levels. As you turn the Scroll Control
the desired level.
— the scanner turns the key beep off.
Off

Setting the Audio AGC

[MENU]
Settings
Set Audio AGC
This setting helps balance the audio level you hear as you listen to different radio
sources so you can hear them at a similar volume. Use this setting if you listen to an
audio source that has natural changes in audio level for which you want to
compensate.
You can set the Analog or the Digital mode to be on or off.
to select either on or off specifically for receiving analog channels.
Analog
— Press to select.
On
— Press to select.
Off
, the beep gets louder. Press when you reach
56
, , ,
High Middle Low