Operating The Power Takeoff (Pto) - Toro Z Master Professional 7000 Series Operator's Manual

Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Figure 14
Important:
Make sure that you close the
fuel-shutoff valve before transporting or storing
the machine, as fuel leakage may occur. Set the
parking brake before transporting the machine.
Make sure that you remove the key as the fuel
pump may run and cause the battery to lose
charge.
Operating the Power
Takeoff (PTO)
The power takeoff (PTO) switch starts and stops the
mower blades and any powered attachments.
Engaging the PTO
1. If the engine is cold, allow the engine to warm
up 5 to 10 minutes before engaging the PTO.
2. While seated in the seat, release the pressure on
the traction control levers and place in N
3. Place the throttle in the F
Note:
Engaging the PTO with the throttle at
the half or less position causes excessive wear
to the drive belts.
4. Pull out on the power takeoff (PTO) switch to
engage it
1. PTO on
g032595
Disengaging the PTO
To disengage, push the PTO switch to the O
position (Figure
21
position.
AST
(Figure 15).
Figure 15
2. PTO off
15).
.
EUTRAL
g000937
FF