Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
1.
Unlatch the engine hood and raise the engine
hood to gain access to fuse holder
2.
To replace the fuses, pull out on the fuse to
remove it.
3.
Install a new fuse
Figure 48
1. Ignition—30 A (F1)
2. Radiator fan—50 A (large,
heavy duty fuse)
(Figure
(Figure
48).
3. Clutch—10 A (F3)
4. Left fuel tank
Drive System
Maintenance
Adjusting the Tracking
48).
The machine has a knob for adjusting the tracking
located under the seat.
Important:
hydraulic pump neutral before adjusting the
tracking. Refer to
Neutral Position (page 52)
Hydraulic Pump Neutral Position (page
1.
Push both control levers forward the same
distance.
2.
Check if the machine pulls to 1 side. If it does,
stop the machine and set the parking brake.
3.
Unlatch the seat and tilt the seat forward to
access the tracking knob.
Note:
Determine the left and right sides of the
machine from the normal operating position.
4.
To make the machine go right, turn the knob
toward the right side of the machine. Refer to
Figure
49.
5.
To make the machine go left, turn the knob
toward the left side of the machine. Refer to
Figure
49.
g012492
6.
Repeat adjustment until the tracking is correct.
43
Adjust the handle neutral and
Adjusting the Control Handle
and
Setting the
55).