Think Safety First - Toro Z Master Professional 7000 Series Operator's Manual

WARNING
There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
1. Remove the hairpin cotters and remove the 2
pins (Figure 8).
2. Lower the roll bar to the down position. There
are 2 down positions. See
positions.
1. Full down position
3. Install the 2 pins and secure them with the
hairpin cotters (Figure
Figure 7 for the
Figure 7
2. Down position with bagger
installed
8).
1. Roll bar
2. Raised position
4. To raise the roll bar, remove the hairpin cotters
and remove the 2 pins
5. Raise the roll bar to the upright position and
install the 2 pins and secure them with the
hairpin cotters

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
g004954
DANGER
Operating the machine on wet grass or steep
slopes can cause sliding and loss of control.
• Do not operate on slopes greater than 15
degrees.
• Reduce speed and use extreme caution on
slopes.
• Do not operate the machine near water.
DANGER
Wheels dropping over edges can cause
rollovers, which may result in serious injury,
death, or drowning.
Do not operate the machine near drop-offs.
18
Figure 8
3. Pin
4. Hairpin cotter
(Figure 8).
(Figure 8).
g004955