Filling The Fuel Tank; Checking The Engine-Oil Level; Switching The Fuel Tanks; Using The Rollover Protection System (Rops) - Toro Z Master Professional 7000 Series Operator's Manual

•
The blended fuel composition should meet ASTM
D975 or EN590.
•
Painted surfaces may be damaged by biodiesel
blends.
•
Use B5 (biodiesel contend of 5%) or lesser blend
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may degrade over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your distributor if you wish for more
information on biodiesel.

Filling the Fuel Tank

Note:
Do not fill the fuel tank completely full. Fill the
fuel tank to the bottom of the filler neck. The empty
space in the tank allows the gasoline to expand.
1. Shut the engine off and set the parking brake.
2. Clean around each fuel-tank cap and remove the
cap. Fill the fuel tank to the bottom of the filler
neck. This space in the tank allows the fuel to
expand. Do not fill the fuel tank completely full.
3. Install the fuel-tank cap securely. Wipe up any
fuel that may have spilled.
4. If possible, fill the fuel tank after each use. This
minimizes possible buildup of condensation
inside the fuel tank.
Checking the Engine-Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine-Oil Level (page

Switching the Fuel Tanks

Important:
Do not run the machine out of fuel.
This may cause engine damage and require the
fuel system to be checked.
The fuel-selector valve is located behind the left side
of the seat.
The unit has 2 fuel tanks. One tank is on the left side
and the other on the right side. Each tank connects
to the fuel-selector valve. From there a common fuel
line leads to the engine
To use the left side fuel tank rotate the fuel-selector
valve to the left-hand location. To use the right side
37).
(Figure 6).
fuel tank rotate the fuel-selector valve to the right-hand
location (Figure 6)
Close the fuel-selector valve before transporting or
storing machine.
1. Left fuel tank
Using the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep
the roll bar in the raised locked position and
use the seat belt.
Ensure that the rear part of the seat is secured
with the seat latch.
17
Figure 6
2. Fuel-selector valve
g000962