Konica Minolta Bizhub 4000i User Manual page 276

Level 1 Level 2
2-sided 2-sided Print Select whether to print on both sides of the paper.
Single Image
Paper Type MP Tray
Tray1
Tray2
Tray3
Tray4
Paper Size MP Tray
Tray1
Tray2
Tray3
Tray4
Paper Low Notification
Notice
Notice Level
Check Size -
1 Available if the Optional Tray(s) is installed.
2 Only for certain model
[General Setup]
Level 1 Level 2
Local Language -
Resolution -
Density -
Ecology Toner Save
Sleep Time
Quiet Mode
Auto Power Off Set the number of hours that the machine will remain in Deep Sleep Mode
Panel Control Button Repeat
Message Scroll Set the time in seconds that an LCD message will scroll across the LCD.
LCD Contrast
Auto Online
Setting Lock -
Interface Select
Description
For a print job where the last page is a 1-sided image, select the 1-sided
Feed option to reduce printing time.
When you use Letterhead or Preprinted paper, you must select the 2-
sided Feed option. If you select 1-sided Feed for Letterhead or
Preprinted paper, the last page will be printed on the reverse side.
Select the paper type that matches the paper in the MP tray.
Select the paper type that matches the paper in the standard paper tray.
1 Select the paper type that matches the paper in the Optional Tray (Tray 2).
1 Select the paper type that matches the paper in the Optional Tray (Tray 3).
1 2 Select the paper type that matches the paper in the Optional Tray (Tray 4).
Select the size of paper you loaded in the MP tray.
Select the size of paper you loaded in the standard paper tray.
1 Select the size of paper you loaded in the Optional Tray (Tray 2).
1 Select the size of paper you loaded in the Optional Tray (Tray 3).
Select the size of paper you loaded in the Optional Tray (Tray 4).
1 2
Select whether to display a message telling you that the paper tray is nearly
empty.
Select the minimum paper level that will trigger the message.
Select whether to display a message telling you to check that the size of the
paper in the machine and the machine's Paper Size setting match.
Description
Select the LCD language for your country.
Choose a print resolution.
Increase or decrease the print density.
Increase the page yield of the toner cartridge.
Set how much time will pass before the machine enters Power Saving
Mode.
Decrease printing noise.
before going into Power Off Mode.
Set the time for the LCD message to change when holding a or b at
intervals.
From Level 1=0.2 sec to Level 10=2.0 sec.
Adjust the contrast of the LCD.
Set the machine to return to Ready Mode after it has been idle for 30
seconds.
Lock your machine's settings using the Setting Lock password.
Select the interface to use.
272