Konica Minolta Bizhub 4000i User Manual page 199

Error Message
Drum !
Drum End Soon
Jam 2-sided
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray 1
Jam Tray 2
Jam Tray 3
Jam Tray 4
Limit Exceeded
Media Mismatch
No Drum Unit
No Paper
No Paper Fed T1
No Paper Fed T2
No Paper Fed T3
No Paper Fed T4
Cause
The corona wire on the imaging
unit must be cleaned.
The imaging unit or the toner
cartridge and imaging unit
assembly is not installed correctly.
The imaging unit is near the end
of its life.
The paper is jammed in the 2-
sided tray or inside the back
cover.
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray.
The paper is jammed in the back
of the machine.
The paper is jammed in the
indicated paper tray.
The print limit set in Secure
Function Lock 3.0 was reached.
The media type specified in the
printer driver differs from the
paper type specified in the
machine's menu.
The imaging unit is not installed
correctly.
The machine is out of paper, or
paper is not loaded correctly in the
paper tray.
The machine failed to feed paper
from the indicated paper tray.
Action
Clean the corona wire on the imaging unit.
See Related Information: Clean the Corona
Wire.
If the problem continues, replace the imaging
unit with a new one.
Remove the imaging unit, remove the toner
cartridge from the imaging unit, and put the
toner cartridge back into the imaging unit.
Reinstall the imaging unit in the machine.
Order a new imaging unit before the LCD
displays Replace Drum.
Remove the 2-sided tray and open the back
cover to pull out all jammed paper.
Open the front cover, remove the toner
cartridge and imaging unit assembly, and pull
out all jammed paper. Close the front cover.
Remove all jammed paper from in and around
the MP tray. Press Go.
Open the fuser cover and remove all jammed
paper. Close the fuser cover.
Pull out the paper tray indicated on the LCD
and remove all jammed paper.
Call your administrator to check your Secure
Function Lock Settings.
Load the correct type of paper in the tray
indicated on the LCD, and then select the
correct media type in the Paper Type setting
on the machine.
Reinstall the toner cartridge and imaging unit
assembly.
• Refill paper in the paper tray. Make sure
the paper guides are set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
Pull out the paper tray indicated on the LCD
and remove all jammed paper.
195