Table of Contents
Advertisement
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
28,
Figure
29, and
Figure 28
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 29
1. Anti-scalp roller
2. Bushing
Figure
Figure
30.
4. Flange nut
5. Bolt
3. Flange nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing
Adjusting the Flow Baffle
Cam Locks
This procedure is applicable only to machines with the
flow-baffle locks. Certain models have nuts and bolts
in place of the flow-baffle locks and can be adjusted
the same.
g029955
You can adjust the mower-discharge flow for different
types of mowing conditions. Position the cam locks
and baffle to give the best quality of cut.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
To adjust the cam locks, swing the lever up to
loosen the cam lock
4.
Adjust the baffle and cam locks in the slots to
the desired discharge flow.
5.
Swing the lever back over to tighten the baffle
and cam locks
g029956
6.
If the cam locks do not lock the baffle into place
or it is too tight, loosen the lever and then rotate
the cam lock.
Note:
Adjust the cam lock until the desired
locking pressure is achieved.
26
Figure 30
4. Flange nut
5. Bolt
(Figure
31).
(Figure
31).
g029957
Advertisement
Table of Contents
