Volvo XC90 Owner's Manual page 531

1. Turn on the vehicle's hazard warning flashers
if a wheel change must be performed in an
area with traffic.
2. Apply the parking brake and put the gear
selector in P, or first gear if the vehicle has a
manual transmission.
Leveling Control
For vehicles with
vehicle is equipped with pneumatic suspen-
sion, this must be switched off before the
vehicle is lifted with the jack*.
3. Take out the jack*, lug wrench* and tool for
removing the plastic covers, which are
stowed in the foam block.
Tool for removing the plastic covers on the wheel bolts.
4. Place chocks in front of and behind the
wheels that are still on the ground. For exam-
ple, use heavy wooden blocks or large
stones.
5. Using the lug wrench, screw the towing eye
into place as far as possible according to the
instructions.
*: If the
CAUTION
The towing eyelet must be screwed into the
lug wrench* as far as possible.
6. Remove the plastic covers from the wheel
bolts using the designated tool.
7. With the vehicle still on the ground, use the
lug wrench/towing eye to loosen the wheel
bolts ½-1 turn by pressing downward (coun-
terclockwise).
WHEELS AND TIRES
8. When hoisting the vehicle, it is important that
the jack or garage lift arms are positioned on
the designated points under the vehicle. The
triangle markings on the plastic cover indi-
cate where the jack attachment points/lifting
points are located. There are two jack attach-
ment points on each side of the vehicle.
There is a groove for the jack at each attach-
ment point.
9. Position the jack under the attachment point
being used, ensuring that the surface is firm,
flat and not slippery.
}}
529
* Option/accessory.