Volvo XC90 Owner's Manual page 445

22
4. Locate the "training" button
receiver for the e.g. garage door opener. It is
usually located near the antenna bracket on
the receiver.
5. Press and release the "training" button once.
Programming must be completed within 30
seconds after pressing the button.
6. Press and release the HomeLink
be programmed. Repeat the press/hold/
release sequence a second time. For some
receivers, the sequence may need to be
repeated a third time.
> Programming is now completed and the
garage door, gate, etc. should now be
activated when the programmed button is
pressed.
If you experience any difficulties programming,
®
please contact HomeLink at:
www.HomeLink.com, or call 1–800–355–3515.
22 The name and color of the button varies depending on the manufacturer.
Certain markets only.
23
Programming individual buttons
To program an individual HomeLink
1. Press and hold the desired button for about
20 seconds.
2. When the indicator light on HomeLink
starts flashing slowly, it is possible to pro-
gram as usual.
Note: If the button you are reprogramming
does not program with a new device, it will
on the
return to the previously saved programming.
Resetting the HomeLink
It is only possible to reset all HomeLink
at once. It is not possible to reset individual but-
tons. Individual buttons can only be reprogram-
med.
®
button to
Press and hold the outer buttons (1 and 3)
–
on HomeLink
> When the indicator light goes from a
steady glow to flashing, the buttons have
been reset and are ready for reprogram-
ming.
Related information
•
Using HomeLink
•
HomeLink
•
Type approval for HomeLink
®
button:
®
®
buttons
®
buttons
®
for about 10 seconds.
®
* (p. 443)
®
* (p. 441)
®
* (p. 444)
STARTING AND DRIVING
®
23
Using HomeLink
*
®
Once HomeLink is programmed, it can be
used instead of the separate remote controls.
Press and hold the programming button. The
garage door, gate, alarm system, etc. will be acti-
vated (this may take several seconds). If the but-
ton is held down for more than 20 seconds,
reprogramming will begin. The indicator light will
glow steadily or flash when the button has been
pressed. The original remote controls may be
used concurrently with HomeLink
NOTE
When the ignition is switched off, HomeLink
will be active for at least 7 minutes.
NOTE
®
HomeLink cannot be used if the vehicle is
locked and the alarm is armed* from the out-
side.
®
if desired.
®
}}
443
* Option/accessory.