Volvo XC90 Owner's Manual page 444

STARTING AND DRIVING
||
programmable buttons and an indicator light in
the mirror.
For more information about HomeLink
visit: www.HomeLink.com or call
1-800-355-3515.
Save the original remote controls for future pro-
gramming (e.g. for use in another vehicle). It is
also advisable to delete the button programming
if the vehicle is sold.
Related information
®
•
Using HomeLink * (p. 443)
•
Programming HomeLink
•
Type approval for HomeLink
19 Certain markets only.
20 HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
Certain markets only.
21
442
Programming HomeLink
Follow these instructions to program
®
HomeLink
, please
individual buttons.
NOTE
In some vehicles, the ignition must be on or in
the "accessory position" before HomeLink
can be programmed or used. It can be a good
idea to put new batteries in the remote con-
trol being replaced by HomeLink
programming and better radio signal trans-
®
mission. The HomeLink
* (p. 442)
reset before programming.
®
* (p. 444)
WARNING
While HomeLink
garage door or gate being programmed may
be activated. Make sure that no one is near
the door or gate during programming. When
programming a garage door opener, it is
advised to park outside of the garage.
®
21
*
®
, reset all programming, or program
®
for faster
®
buttons should be
®
is being programmed, the
1. Point the remote control at the HomeLink
button to be programmed and hold it about
2-8 cm (1-3 inches) from the button. Do not
obstruct the HomeLink
Note: Some remote controls are more effec-
tive at programming HomeLink
tance of about 15-20 cm (6-12 inches).
® Keep this in mind if you experience any pro-
gramming difficulties.
2. Press and hold both the remote control but-
ton and the HomeLink
grammed.
3. Do not release the buttons until the indicator
light has stopped flashing slowly (about once
a second) and either flashes quickly (about
10 times a second) or glows steadily.
> If the indicator light glows steadily:
Indication that programming is complete.
Press the programmed button twice to
activate.
If the indicator light flashes quickly:
The device being programmed with
®
HomeLink may have a security function
that requires an extra step. Try pressing
the programmed button twice to see
whether the programming works. Other-
wise, continue with the following steps.
®
®
indicator light.
®
from a dis-
®
button to be pro-
* Option/accessory.