Installing The Cabinet Mounting Bracket - ADC Digivance NXD Installation And Maintenance Manual

Radio access node (ran)
Hide thumbs Also See for Digivance NXD:
Table of Contents

Advertisement

ADCP-75-210 • Issue 1 • March 2007
Three load types should be considered: static weight loading, ice loading, and wind loading.
These types should be considered on the pole, wires, and any equipment installed on the pole.
A qualified engineer should perform the pole loading analysis, taking into account both vertical
and horizontal forces. The specified horizontal load is applied 2 ft. (60.1 cm) from the top and
the assumption is that the pole acts as a cantilever with maximum stresses applied at the ground
level.
Table 20
The strength of the wood pole is defined in Standard Handbook for Electrical Engineers, 13th
Edition, McGraw Hill, Chapter 18, Section 135, "Strength of Wood Poles," Pages 18-57. The
wood pole strength calculation is defined in Standard Handbook for Electrical Engineers, 13th
Edition, McGraw Hill, Chapter 18, Section 136, Reference NEC.
2.5.3

Installing the Cabinet Mounting Bracket

The Digivance NXD Wood Pole Mounting Bracket, shown in
that is used to attach the Digivance NXD cabinet to a power distribution pole or related object.
The bracket is attached to the pole using galvanized steel square head bolts that are attached
through holes drilled through the wooden pole. An example of an installed NXD wood pole
mounting bracket is shown in
Use the following procedure to install the RAN wood pole mounting bracket:
1. Determine the mounting height of the RAN and mark the pole at the desired location of
the base of the RAN.
Note: Install the RAN pole mount bracket on the side of the utility pole assigned by the
utility company or required by local zoning.
Page 36
© 2007, ADC Telecommunications, Inc.
Table 19. RAN Component Weights
CONFIGURATION OR COMPONENT
Base RAN without batteries
Base RAN with four batteries
Expansion RAN with four batteries
Antenna pole-mount bracket (9 inch)
Antenna pole-mount bracket (2 inch)
Pole-top antenna (9 inch)
Pole-top antenna (2 inch)
provides acceptable loads by pole class.
Table 20. Loading by Pole Class
POLE
CLASS
1
2
3
Figure
26.
WEIGHT
379 lbs. (172.3 kg)
679 lbs. (308.6 kg)
619 lbs. (281.4 kg)
56 lbs. (25.5 kg)
57 lbs. (25.9 kg)
47 lbs. (21.4 kg)
12 lbs. (5.5 kg)
HORIZONTAL LOAD
5400 lbs. (2454.5 kg)
3700 lbs. (1681.8 kg)
3000 lbs. (1363.6 kg)
Figure
26, is an accessory item

Advertisement

Table of Contents
loading

Table of Contents