Table of Contents
Advertisement
4.1.2
Installing a Systems Interface (STF2) Module
The System Interface module (STF2) is installed into Slot 6 of the RAN Chassis. Only one
STF2 module may be installed per RAN chassis.
Note: For a description of the STF2 module including function, controls, and indicators,
refer to
Section 1.7.3 on Page
Figure 40 on Page
Use the following procedure to install the STF2 module
1. Open the RAN door.
2. Locate the designated slot for the STF2 module. The module installs into Slot 6.
3. Remove the STF2 module from the anti-static packaging and orient for installation.
4. Slide the STF2 module into the designated slot within the RAN chassis.
5. Lock the IEL handles on the top and bottom of the STF2 module into the cPCI chassis and
tighten the handle screws.
6. Using cable 1001474P001, connect the RAN door switch to the RJ-45 connector labeled
DA (Door Alarm) on the front of the STF2 module.
7. Using cable 1955000P084, connect the GPS antenna to the SMA connector labeled ANT
(Antenna) in the center of the module.
8. Using cable 1001476P001, connect the RECT port on the STF2 module to the unlabeled
9-pin port on the Low Voltage Disconnect (LVD) unit. For location of the LVD port, refer
to
Section 1.8.2 on Page
14. For a RAN chassis interconnection diagram, refer to
58.
24.
Figure 43. Installing an STF2 Module
ADCP-75-210 • Issue 1 • March 2007
(Figure
43):
© 2007, ADC Telecommunications, Inc.
21252-AX
Page 61
Advertisement
Table of Contents
