Table of Contents
Advertisement
ADCP-75-210 • Issue 1 • March 2007
4. Pull out the battery drawer.
5. Move the gravity latch to the down position. Lock the telescopic slide into the locked out
position.
6. Install the batteries in the drawer as follows, referring to
and
Figure 37
a. Place the batteries in the drawer in the configuration shown.
b. Wire the batteries in series as shown.
c. Find the wiring harness coiled up on the floor of the battery back up drawer and plug
the Anderson connectors together as shown.
7. Move the gravity latch up, push the battery drawer in, and move the gravity latch down.
8. Reconnect the battery disconnect switch (DISC) on the LVD unit. For location, refer to
Figure 19 on Page
off when the batteries are reconnected.
Page 52
© 2007, ADC Telecommunications, Inc.
for extended batteries:
24. The LVD LED on the low voltage disconnect unit should will turn
BATTERY
DRAWER
Figure 35. Open Battery Drawer
Figure 36
for extended batteries
GRAVITY
LATCH
21277-A
Advertisement
Table of Contents
