Table of Contents
Advertisement
ADCP-75-210 • Issue 1 • March 2007
This module also provides a CW test tone for use in reverse continuity testing. The RF signals
are input into the module by way of coax cables terminated with SMA connectors on the
faceplate (at the ports labeled PRI IN and DIV IN).
Table 8
describes the module faceplate components called out in the figure.
REF #
DESIGNATION
1
PRI IN
2
DIV IN
3
FLT
4
PWR
Page 18
© 2007, ADC Telecommunications, Inc.
Figure 13. RAN Down Converter Module Faceplate
Table 8. RAN Down Converter Module Faceplate Components
DEVICE
FUNCTIONAL DESCRIPTION
SMA connector
Primary In. Receives RF primary output from either C/PMC-
PLR or P/MCPLR module. Connection is made using cable
1955000P081
SMA connector
Diversity In. Receives RF diversity output from either C/
PMCPLR or P/MCPLR module. Connection is made using
cable 1955000P081
Red LED
Fault. Lights when module has failed and during start-up until
module has initialized; blinks after module receives a system
clock and is awaiting initialization
Green LED
Power. Lights when module has power
Figure 13
shows the module faceplate.
PRIMARY
1
IN
DIVERSITY
2
IN
FAULT
3
LED
POWER
4
LED
21236-A
Advertisement
Table of Contents
