Table of Contents
Advertisement
Note: To insure that all optical connectors and optical ports remain dust-free during
installation, leave all dust caps and dust protectors in place until directed to remove them
for installation.
1. Checking out and preparing the installation site.
2. Unpacking and inspecting the shipped items.
3. Installing a pole mount frame or pedestal mount.
4. Installing the RAN cabinet on the pole or pad.
5. Installing the rain shields (pole mount) or pedestal enclosure (pad mount).
6. Installing the solar shield.
7. Installing a ground wire.
8. Connecting RF cables between the antenna and RAN.
9. Installing the fiber optical cable that connects the RAN to the Hub.
10. Installing AC power.
11. Installing backup batteries in the cabinet.
2.2
Unpacking and Inspection
The RAN is shipped to the field pre-configured with all modules and components that the
customer has ordered. Electronic modules except for the batteries are shipped already installed
in the cabinet.
The following optional accessories may also be shipped with the RAN:
• Back-up batteries
• Non-standard SFP optical transceiver
Use the following procedure to unpack and inspect the RAN components:
1. Open the shipping cartons and carefully unpack each component from the protective
packing material.
2. Check each component for broken or missing parts. If there are damages, contact ADC for
an RMA (Return Material Authorization) and to reorder if replacement is required. For
contact information, refer to
2.3
Required Materials and Tools
The following materials must be supplied by the installer:
• (Pole mount only) Three galvanized steel square headed bolts with minimum tensile
strength of 20,050 lbs., 3/4 in. diameter, and of a length appropriate to pole diameter;
Three nuts for bolts, three flat washers, three split ring washers, and three 3-in. square
curved washers (see
Section 6 on Page
Figure 27 on Page
39)
ADCP-75-210 • Issue 1 • March 2007
72.
© 2007, ADC Telecommunications, Inc.
Page 31
Advertisement
Table of Contents
