Table of Contents
Advertisement
70
Installing and Removing Hardware
Power Supply Unit
5 Disconnect the power cable and signal cable.
Disconnecting the cables
Installing the power supply unit
NOTE: The installation and replacement of the power supply
unit requires special technology and knowledge. If you have
no experience in installing the power supply unit or if you
need assistance, consult your authorized MAGNIA service
provider.
Before installing the power supply unit, carefully read "Before
starting operation" on page 48 and proceed as follows:
1 Confirm that the power supply is switched off.
2 Confirm that the power cable is disconnected from the AC out-
let.
3 Remove the outer covers and server panels from the server.
See "Removing and replacing the server panels" on page 54.
Advertisement
Table of Contents
