Table of Contents
Advertisement
234
Following message is displayed on the front panel display and
the power is automatically turned off if BIOS recovery was
succeeded.
BIOS Recovery Boot succeeded.
6 Following message is displayed if BIOS recovery was failed.
Return to step 5 and repeat recovery process.
BIOS Recovery Boot failed.
7 Disconnect the AC power cable.
8 Remove the server panles, power supply unit and board for
wireless card, and return the jumper switch to 1-2 short
9 Replace the board for wireless card, power supply unit and
server panles.
10 Connect the AC power cable again and restart your server.
11 Start the BIOS Setup Utility and select "Load Setup Default"
from the Exit menu to execute it.
NOTE: In addition to the hardware setup switch and recovery
boot switch, several jumper switchs are located on the moth-
erboard. Do not disturb the settings of any switchs other than
the above two, since incorrect setting may result in malfunc-
tion.
Advertisement
Table of Contents
