Table of Contents
Advertisement
102
Installing and Removing Hardware
Hard Disk Drive (HDD) –IDE HDD–
Pulling out the hard disk drive
5 Install a new hard disk drive in the same procedure as for
extension.
See "Installing the hard disk drive" on page 98.
6 After a short time, confirm that the PWR indicator lights up.
7 Attach the front panel.
8 Recover (rebuild) the disk.
NOTE: If the server uses IDE RAID for redundancy, the oper-
ation is continued by a spare device without stopping the sys-
tem, even if one of the hard disk drives that configure a disk
array fails (downgraded operation). However, if another
device fails, it may destroy and lose important programs or
data. Replace the faulty device by a normal one as quickly as
possible, and recover the disk array.
Advertisement
Table of Contents
