Table of Contents
Advertisement
Thermal sensor board
Removing the thermal sensor board
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can replace
them in the same locations.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove all the
drives.
4. Disconnect all the cables from the backplane.
5. Disconnect the control panel cable from the midplane.
6.
Remove the drive cage from the
Steps
1. Using the Phillips #1 screwdriver, remove the screw that secures the thermal sensor board assembly to the drive cage.
2. Disconnect the cable from the sensor board assembly.
3. Remove the screw that secures the sensor board to the drive cage, and lift the board away.
Figure 77. Removing the sensor board
Next steps
1.
Install the sensor
board.
Installing the thermal sensor board
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly on the chassis to prevent them from being pinched or crimped.
82
Installing and removing enclosure components
Safety
instructions.
Before working inside your
chassis.
enclosure.
Advertisement
Table of Contents
