Figure 44. Installing the PIB
Next steps
1. Reconnect all the disconnected cables.
2.
Install the power supply
3. Follow the procedure listed in
Chassis management board
Removing the chassis management board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the power supply
4.
Remove the power interposer
5. Disconnect all the cables that are connected to the chassis management board.
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the chassis management board to the chassis.
2. Sliding the board toward the front of the enclosure, lift the board away after the guide slots are free of the standoffs.
units.
After working inside your
Safety
instructions.
Before working inside your
units.
board.
enclosure.
enclosure.
Installing and removing enclosure components
57