Figure 34. Installing the system cover
Next steps
1. Reconnect the peripherals, and connect the system to the electrical outlet.
2. Power on the system, and all attached peripherals.
Backplane cover
Removing the backplane cover
Prerequisites
NOTE:
This procedure is not applicable for enclosures with the 3.5-inch hard drive configuration.
1. Follow the safety guidelines listed in
Safety
instructions.
2. Follow the procedure listed in
Before working inside your
enclosure.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the backplane cover to the enclosure.
2. Slide the backplane cover toward the back of the enclosure and lift the cover away.
Installing and removing enclosure components
49